We'll use one sample load throughout: $2,400 for 1,000 loaded miles, with 75 miles of deadhead to the pickup.
1. Posted rate per mile vs rate with deadhead
The rate per mile on a load counts only the trip itself: rate divided by loaded miles. Our sample pays $2.40 per loaded mile.
But the truck also has to drive empty to the pickup. Divide the rate by all 1,075 miles and it pays $2.23. That's the number to compare loads on: a higher posted rate with a long deadhead can lose to a lower rate close by.
2. Market averages are a reference, not a target
DAT One shows average rates for a lane, built from past loads, and higher plans show fresher averages. They help you see whether a broker's offer is low for the market, and give you a reason for your counteroffer.
An average doesn't know your truck, though. A lane can pay the market average and still lose money for a truck with high payments or poor fuel economy. Use the average to negotiate, and your own costs to decide.
3. Check what the rate includes
Spot rates on the board are usually all-in, with fuel included. Some brokers quote linehaul plus a fuel surcharge. Add the two before you compare, or a load can look cheaper than it is. Also ask about detention, lumper and extra stops, which can change the real rate per mile a lot.
4. Turn the rate into profit
For our sample load, take out fuel ($628), other truck costs ($806), tolls ($40), the dispatch fee ($192) and factoring ($72). That leaves $661, or $0.62 per mile.
The same math gives you your limits: the load breaks even at $1,657, and to clear $500 you need $2,219 or more. Try it with your own numbers in the load profit calculator.
5. Know your own cost per mile
Everything above depends on one number: what a mile costs your truck. Add up fuel, payments, insurance, maintenance, permits, ELD and driver pay, then divide by the miles you run in a month. The cost per mile calculator does it in a minute. Any rate per mile below that number, counted across all miles, loses money.
So what is a good rate per mile?
There is no single good number for every truck. A good rate per mile is one that clears your cost per mile across all miles, deadhead included, and leaves the profit you want on top.
For our sample load, breaking even takes $1,657, which is $1.54 across all 1,075 miles. Clearing $500 takes $2,219, or $2.06. Those two numbers are this truck's floor and target. Yours will differ, so work them out once and judge every load on the board against them, not against the posted RPM or the market average.
LoadSense is an independent product by INNOSOFT SOLUTIONS SRL. DAT and DAT One are trademarks of their respective owners; we are not affiliated with or endorsed by them.